You may want to check this out, It gives an idea of how a speaker works and makes everything a bit more clear. You should have no problems using an extension to move the speakers farther apart. This again does not look any different then a normal stereo amplifier setup(Amp takes the input signal and makes it big enough to drive the speakers the speakers then selves are powered off this amplified signal) except that your amp is contained within one speaker. The signal coming from that plug is amplified(powered if you will, it is much stronger then the one that entered the system from the computer) and is at a higher voltage audio signal that the speaker will playback without need for any other power source. The wires for the one speaker are clearly internal and the other has the long(but not long enough wire) heading to the other speaker. Inside that speaker, the amplifier makes the incoming signal powerful enough to drive the speakers. That same speaker also gets the stereo audio signal. Our Standard Service includes re-magnetizing old Alnico high and low frequency loudspeakers to restore their original magnetic strength at no extra charge. In this case, you have power(12 volts if I see it right) running into one speaker. Great Plains Audio is the premier repair center for Altec Lansing loudspeakers manufactured before 2005.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |